Sakda CD Controller

[audiosteve]

Does anyone have the schematic and layout for the Rev 2. board that Sakda sells?

http://www.audiodesignguide.com/sakdaweb/

I just received mine and it is not working.
Three E-mails to Sakda have resulted in no response.

I need to try to figure out what is wrong and get this board going.
Thanks in advance for any help.

[audiosteve]

In reponse to Zanuda's reply on:

http://www.diyaudio.com/forums/showt...17#post1371717

The LCD is dead. No voltage on the CD-ROM power connector. Supply to the board is good. I will dig deeper as soon as I can but I'd like to find a schematic first. I haven't checked Vcc on the processor or the processor clock yet.

Thanks

[Zanuda]

Did you apply voltage where is should go? May be there is other way to power the bord up?

[audiosteve]

Zanuda,

I appreciate your attempt to help. But I am not that helpless. I am just looking for a schematic right now and hopefully someone in the community has one. As I said before, I haven't tried to do much yet without one. But when I get one (or if I don't) I am sure I will be capable of getting back to it and checking out the basic things you have outlined.

Thanks

[Zanuda]

Sakda answered my E-mail, so he is online and alive...

[audiosteve]

Thanks Zanuda. I will try him yet again. He did finally respond a day ago and asked what I wanted (even though what I was looking for was in the E-mail he was responding to). So I asked him again and again have gotten no reply. I wonder if he has trouble getting internet access? His responses so far have been slow or non-existent except for the response to my initial order of the controller. I don't know if this is coincidence or by design, but whatever the reason, it has been very frustrating.