|Digital Source Digital Players and Recorders: CD , SACD , Tape, Memory Card, etc.|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
||Thread Tools||Search this Thread|
|6th December 2007, 11:02 AM||#1|
Join Date: Oct 2006
Help TDA 4X 1541 balanced Mode
Need your help for my project. 4 or more TDA 1541A in balanced mode
CS8414 receiver ( 2 separates regulations with TL431)
Recloking with HC4040 (TL431). Accordind to Douma schematic
X0 clock 2.882 (Jung regulator)
Split I2S with HEF4517 from Philips (Guido advice) according to Pedja schematic
Dem Clock with HC161 according to Ecdesign schematic (TL431)
Buffer 74HC125N (TL431)
Don’t pay attention to the value of each componants and sense of capacitors. It is “home made pcb” without printing
All is working very well; j have tested it with 2X 12TDA1543 in // with Rikken and 20UF PIO;
Near the receiver you can see a connector for a daughter board in order to test several systems in order to play with spdif (transformes, …)
The design offer me the opportunity to add, like a tower sytem many pcb in order to have 2X 1,2,3,4, … TDA 1541A in //
At the oupout, j have already a D1 Jfer. Maybye a low pass filter in the future
My questions , before making the pcb ….
1. Pin 18 and 13. Decoupling caps
J do not understand why only these 2 capacators are different from the others. It is what j have seen on Pedga and Torsten Dac ?
J have done the same .
2 Usually pin 2 and 4 are connected together for BCK
On the “Dac.zip” from Guido , BCK is Pin 3 and Pin 4 is connected to pin 5
J do not know what to do ?
2. Power supply
J have read the “thread “more info about TDA”, but j haven’t enough knowledge in order to understand the conclusion.
+ 5 and -5V are decoupled from Dgnd
- 15v is decoupled from A Gnd
It is what j have done.
Thanks for your help, excuse for my poor English and knowledge.
It is just a mixing of several schematics, thanks to all guys for informations.
|6th December 2007, 04:12 PM||#2|
Join Date: Oct 2006
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Using a spdt switch to select between triode mode and pentode mode on a guitar amp.||G||Instruments and Amps||19||15th March 2006 09:15 AM|
|PCM1798 mono mode with balanced output help||mpopovics||Digital Source||8||24th September 2005 10:00 PM|
|1541 passiv I/V idea & 1541 S1 found, no A !||Bernhard||Digital Source||6||9th April 2004 09:18 AM|
|My new multichanel passive balanced pre-amp/solar powerd(tube mode)/remotecontrol.||Brian Guralnick||Tubes / Valves||0||5th October 2003 10:11 PM|
|New To Site?||Need Help?|