|
|||||||
| Home | Forums | Rules | Articles | Store | Gallery | Blogs | Register | Donations | FAQ | Calendar | Search | Today's Posts | Mark Forums Read | Search |
| Digital Line Level DACs, Digital Crossovers, Equalizers, etc. |
  |
|
|
|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving |
 |
|
|
Thread Tools | Search this Thread |
2nd April 2006, 09:09 PM
|
#1 |
|
diyAudio Member
Join Date: Nov 2004
Location: So. Cal
|
DCX2496 front panel problem
I purchased a "refurbished" DCX 2496 on ebay a couple of months ago. Unfortunately, I didn't have a chance to test it till this weekend, and the unit is intermittent.
The problem stems from the 26 pin connector between the front panel PCB and the processor board. If I apply pressure to the connector one the front panel with my fingers, it will operate properly. Otherwise, it will not boot properly. Seems like a bad contact of some sort. Has anyone seen this problem? Is there a good fix, short of attempting to dismantle the front panel assembly? I am afraid that if I dismantle the FPA, it may never go together properly again.
__________________
Jim |
|
|
| Thread Tools | Search this Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY amps front panel lettering | KenP | Solid State | 40 | 2nd February 2011 10:19 AM |
| Front Panel / Enclosure Help | tumler | Parts | 8 | 7th August 2007 08:41 AM |
| Front Panel Manufacture | Bonsai | Parts | 5 | 21st December 2006 03:01 AM |
| DIY Front Panel !! | udip | Solid State | 12 | 16th January 2005 06:37 AM |
| Aluminium for front panel | jouch | Solid State | 7 | 15th March 2001 10:51 PM |
| New To Site? | Need Help? |
