PCM1704 dirty output
sorry if it's a very basic question, but i can't figure it out myself...
the attached waveforms were captured while playing back an 1khz 0dbfs sine with 8x oversampling (fs=44.1khz). the i/v stage is an 8 ohm resistor to ground (for this measurement).
what i was expecting is a relatively pure staircase pattern. i assume there is some high frequency dirt on the signal. do you guys have any idea?
It appears to be random noise; most likely is measurement-related. Try a bigger value for the IV resistor like 100 ohms to see if looks the same.
|All times are GMT. The time now is 04:18 AM.|
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright ©1999-2017 diyAudio