|Digital Line Level DACs, Digital Crossovers, Equalizers, etc.|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
||Thread Tools||Search this Thread|
|28th June 2012, 06:01 PM||#1|
Join Date: Oct 2010
Help needed building a DAC
i have started building this project and i was planning using PCM1794 instead of 1796 but i have discovered that this DAC's are not pin to pin compatible.
I'm not very used with digital circuits but after some reading i have discovered that 1796 needs some uC to be controlled and 1794 does not.
Knowing that 1794 can be hardware controlled is there any problem if i decide to install a PCM1794 and make de pcb adjustemts and leave the pins from Atmega16 not connected to the PCM like they where designated to be connected to 1796 ?
I suppose (hope) to remain active the source selection implemented in the Atmega16.
Are my ideas viable or i need to make some software adjustments in Atmega ?
Last edited by atupi; 28th June 2012 at 06:37 PM.
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Help needed to start F3 building||laama86||Pass Labs||2||26th November 2010 12:15 PM|
|help needed in building 2-way speaker crossover||davidgale||Multi-Way||1||25th September 2009 12:37 PM|
|Help needed building loudspeakers||sogens||Multi-Way||6||5th October 2007 07:11 AM|
|Building Fostex 126E Help needed||ddmddm||Full Range||1||16th December 2005 05:44 AM|
|Help needed building a sub...||gerbruggeman||Subwoofers||10||3rd October 2003 01:43 PM|
|New To Site?||Need Help?|