Passive output SCR 2496

[tojoko]

Hi there

I have put a passive output in my SCR 2496, it worked fine, but now it is very muffled nearly muted, I bougt a DIY DAC with the AKM AK4396, put a passive output in it and it also is very muffled nearly muted, i use the french article for my output change, that is a high quality cap, 6,8 µF in series, a 2,2 µF paralel and a 1k resistor direct from the AKM DAC chip, am i doing something wrong?
When i use the active stage all sounds normal.
I am no expert, but play around a lot with electronics....

thanks for information, tojoko.

[paulebappie]

Skip the 2,2uF.

Or use something like this:

http://www.linearaudio.nl/Documents/...%20article.pdf

(Figure 2) with or without the muting etc.

If u use unbalanced output, try to keep the load to the + and - out equal. So make it unbalanced after the double filter, (figure 2).