AK4393 Serial Configuration Problem

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Hi all,

I have a current problem using an AK4393 24Bit DAC in serial control mode.

P/S- Pin is configured for serial control -> tied to GND.
All other pins like CKS0..2, DIF0..2, and DFS are also tied to GND as they are internally ored with the register bits.

On the /CSN pin I connected /CS, CCLK and CDTI to an Atmel uC.
The format I send is sampling on falling edge.
The /PDN pin is set low after Power up, and then set high before I start writing to the device.

But no matter what I do it does not react to my write attempts to the serial port.


Has anyone experience with this chip?

Any advice is very welcome.

Thanks, Aoxomox
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.