Hi to everybody, I would like to make a audio innovation 700 , I have managed to source all parts but are not familiar with out to turn a schematic into a hard wire board without using a pcb board. Is there anybody that can help with drawing a layout for hard wiring this schmatic . I have build a couple oh guitar amps from layouts which have worked very well but now want a nice intergrated amp for the living room. I would much appreciate if anybody could help me with this. Many thanks Ian. www.4tubes.com/SCHEMATICS/BY-BRAND/audio-innovations/ai700-pa.gif
Attachments
No. Shown is a mono-block amplifier. Pre-amps are not shown.is that a phono/riia input ?
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.