diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Construction Tips (http://www.diyaudio.com/forums/construction-tips/)
-   -   how do i get water droplet like finish on a pro speaker (http://www.diyaudio.com/forums/construction-tips/222196-how-do-i-get-water-droplet-like-finish-pro-speaker.html)

djchrisquad 25th October 2012 08:40 AM

how do i get water droplet like finish on a pro speaker
 
hi how do i get water droplet like finish on the surface of a pro audio speaker , i have heard that some manufacturers use acrylic liquid
this is the finish i require
http://kingblossomguitars.com/wp-con...rop-finish.jpg
or similar
Thanxs

littlerick 1st November 2012 01:29 PM

look on youtube for airbrushing water droplets, its pretty easy with airbrush.

jackinnj 1st November 2012 02:11 PM

Apply base coat, clear cost and allow to cure. You can then bulk up the "solids" in the clearcoat by allowing the solvent to evaporate a bit and "fleck" with a coarse brush. Cure the finish with some gentle heat. Practice

JMFahey 4th December 2012 04:56 PM

Speaker Cabinet Coatings | Texture Coating for Speakers | Road Cases Protective Coating
and you'll find many youtubes showing how to

tripathidev 3rd January 2013 06:38 PM

apply polyurathene using spray gun! Before apply using polyurathene be careful with the quantity of hardner while mixing ět! lowering the air pressure of the spray gun you can create a water drop texture on your speaker enclosure!

amaco 6th January 2013 10:02 AM

I don't think so, they have so many ways to create water droplets. Best


All times are GMT. The time now is 08:06 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright ©1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2