A DIY event in Denmark?

[Magura]

Henrik just arranged a projector.

So we're down to lacking a whiteboard

LykkeDK has arranged a couple of hefty extension chords with a few outlets, so that should also be fine.
Not that I would mind another few extension chords.

Magura

[Magura]

If time permits, and I get rid of the flue (it's about time that happens), I will try to get these hooked up for the event. Out here at countryside, it sure can't be a problem to find a tractor and a wagon to get them there


Magura

[Magura]

And this is what they look like when dressed.


Magura

[Magura]

Maybe we should have a parts exchange bazaar as well?

Personally I have a substantial amount of part, that sure won't find a place in an amp all of them.

What do you say?


Magura

[Nrik]

Yes OK Magura - let us see your stuff and see if it's something we can use.
If somebody else have stuff they think they can spare - bring it!

It doesn't need that much organising - just a table to put it on, and then you can bring whatever you want to sell or trade, put a note on it, and then people can check it out for themselves in between workshops. Thats it!

[Magura]

Maybe it would be smart, if people tells what they are in need of, as I guess most of us has too much surplus stuff to bring it all.
Then we could bring what each other needs.
I would need a truck and a few people to help if I had to bring all my stuff


Magura


Magura

[Magura]

Ok, I for one would like to narrow down, what should be brought to the "parts exchange pool".

So please chime in.

A few pointers of what I have laying around in quantity:

Heatsinks

Resistors in just about any odd value above 10R, more than the E96 row. From 0.25W to 2W.

Wire of different types, both silicone and teflon insulated.

Magnet wire of just about any diameter.

Loads of the hard to come by types of JFET's (LU1014, 2sk369....)

Rifa peh 169 electrolytics

25.8mm phase plugs

5mm impregnated glass insulation.

Huge pp in oil caps

Directional graphite for heat spreaders.


Plus loads more, so if you're in need of something, grab your parts bin, and let's see if we can swap.


The little detail about this: I need a pointer about what you're interested in from my "parts bin", as the entire load is not going to be brought to the event.

Perhaps you could also post your surplus list.

Magura

[Nrik]

I could maybe be interested in some big electrolytics and heatsinks.
Maybe you could take a picture of the heatsinks and post it - then you dont have to bring them all.

[Magura]

Sorry, no big electrolytics. As I recall, they're 100V 680uF Rifa PEH-169

A couple of pics of the heatsinks.


Magura

[Nrik]

wauw they are sexy. How high are they?