Hello,
I'm now finishing my UcD400 amp recently bought from Hypex Electronics, I've noticed from the manual that there is an /ON (on internal pull-up) pin on the 4-pin connector, to be connected to the supply ground to a switch...
What will be the different between opened and closed switch for this signal?
Thanks,
RR.
I'm now finishing my UcD400 amp recently bought from Hypex Electronics, I've noticed from the manual that there is an /ON (on internal pull-up) pin on the 4-pin connector, to be connected to the supply ground to a switch...
What will be the different between opened and closed switch for this signal?
Thanks,
RR.
Hello RR:
This pin must be connected to ground to power-up the module. Open switch will power-down it. I think it's a very useful tool for delayed start, when PS is stable.
If you have multiple modules it is recommended to make all "ON pin" wires of equal lenght.
Am I wright?
Hope this helps.
Best of lucks.
M
This pin must be connected to ground to power-up the module. Open switch will power-down it. I think it's a very useful tool for delayed start, when PS is stable.
If you have multiple modules it is recommended to make all "ON pin" wires of equal lenght.
Am I wright?
Hope this helps.
Best of lucks.
M
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.