There is a note that those stereo half bridges of that chip can be made to full bridge mono. At 8 ohms with 420 watt of power. Now I want to connect 4 ohm speaker there.
It should just take lower voltage to reach that 420watts and not to hit current limit. Current plans would be feed it with 30+-(maybe it needs even less?).
What ya think? Will it instantly explode? Would it work?
http://www.nxp.com/documents/data_sheet/TDA8954.pdf
It should just take lower voltage to reach that 420watts and not to hit current limit. Current plans would be feed it with 30+-(maybe it needs even less?).
What ya think? Will it instantly explode? Would it work?
http://www.nxp.com/documents/data_sheet/TDA8954.pdf
Would those irs2092 driven work better=?
NEW Assembled HIFI Stereo IRS2092 Class D Power amplifier board 345W+345W
FULL BRIDGE! Voltage is in acceptable limits. There isnt much written about it.
NEW Assembled HIFI Stereo IRS2092 Class D Power amplifier board 345W+345W
FULL BRIDGE! Voltage is in acceptable limits. There isnt much written about it.
Would those irs2092 driven work better=?
NEW Assembled HIFI Stereo IRS2092 Class D Power amplifier board 345W+345W
FULL BRIDGE! Voltage is in acceptable limits. There isnt much written about it.
Actually never mind. If Ill gona put over 100 dollars on amplifier I could add another 100 and get properly built one.
Skytec Sky 3000 MKII Professional PA Amplifier Mobile Party DJ Power Amp 3000W | eBay
Would those irs2092 driven work better=?
NEW Assembled HIFI Stereo IRS2092 Class D Power amplifier board 345W+345W
FULL BRIDGE! Voltage is in acceptable limits. There isnt much written about it.
Who do you write to and why?!?
CURRENT LIMIT! Peak current for 400 W @ 4 ohm is higher than the ICs built in limit.
Physics is the same.
Just buy a complete one, good idea!
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Class D
- TDA8954 at 4ohms bridge