HIFIMEDIY T1 WIREING INSTRUCTIONS HELP

[bull041161]

Hi all have just got my t1 board today and wondered if there was a link any were to show best way to wire this up. As i dont want to make a mistake and break it. I will be useing speaker binding post and phono sockets for the input any help would be great

[bull041161]

Some one must know how to wire these up. Its the signal input that puzles me as there is only 3 wires should it have 2 channels going in there is one red wire 1 white wire and a black any help would be great

[platenspeler]

I think it's probably the same connector as used in the T2 and T3: The connector has three wires. Red (right channel) and white (left channel) go to the middle pins of your RCA connectors. The black wire (middel pin of the connector on the amp board) should be connected to both signal ground connectors of the RCA.

So at the input they share the signal ground. (At the speaker outputs this is not allowed if I remember well).

Maarten

[Nick122147]

hi,
there are some information and pictures here
T1, T1-M, T2, T3, T3S, T4 Amplifier Manual

[bull041161]

Thanks very much nick i get it now. Cant wait to try it

[bull041161]

Originally Posted by platenspeler

I think it's probably the same connector as used in the T2 and T3: The connector has three wires. Red (right channel) and white (left channel) go to the middle pins of your RCA connectors. The black wire (middel pin of the connector on the amp board) should be connected to both signal ground connectors of the RCA.

So at the input they share the signal ground. (At the speaker outputs this is not allowed if I remember well).

Maarten

Thanks very much maarten for help