Topping TP20 mk2 5v

Hendot · 12th July 2011, 01:24 AM

I am about to attempt a project of adding airport expess internals to a Topping TP20 amp. I was hoping to power the airport by soldering a few wires to the amp. It requires 5v and 3.3v.
I notice that the ta2020 chip has a few 5V pins. Would it be possible to pull some power from here to run the airport express, or would this cause problems? I have done a bit of searching and reading datatsheets but haven't found the answer. Can somebody shed some light on this?

celona · 13th July 2011, 09:53 PM

Absolutely no!

Hendot · 14th July 2011, 01:44 AM

I'm thinking now I will get a cheap pico psu from eBay to covert the 12V supply to the 3.3v and 5v required.
I could even use the regulated 5v from the pico psu to supply the 5v pins on the ta2020.

12th July 2011, 01:24 AM	#1
Hendot diyAudio Member Join Date: Jul 2011 Location: Sydney, Australia	Topping TP20 mk2 5v I am about to attempt a project of adding airport expess internals to a Topping TP20 amp. I was hoping to power the airport by soldering a few wires to the amp. It requires 5v and 3.3v. I notice that the ta2020 chip has a few 5V pins. Would it be possible to pull some power from here to run the airport express, or would this cause problems? I have done a bit of searching and reading datatsheets but haven't found the answer. Can somebody shed some light on this?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
TOPPING TP20 vs TP21	edba2000	Class D	5	17th September 2012 01:19 PM
Topping TP10 Mk3 and Topping TP20 impressons?	morfic	Class D	200	17th September 2012 07:35 AM
My Topping TP20 MKII upgrade plan...	gonzalito	Class D	1	10th July 2011 11:11 AM
My Topping TP20 has arrived... What´s next?	gonzalito	Class D	0	15th March 2011 02:04 AM
Topping TP20 TA2020 amplifier	hoxuanduc	Swap Meet	0	25th June 2009 08:14 PM

New To Site?	Need Help?
Register to Participate Search Privacy Statement Contact Us	Frequently Asked Questions Did you forget your password? Mark Forums Read


	Please consider donating to help us continue to serve you. Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving

13th July 2011, 09:53 PM	#2
celona diyAudio Member Join Date: May 2010	Absolutely no!

14th July 2011, 01:44 AM	#3
Hendot diyAudio Member Join Date: Jul 2011 Location: Sydney, Australia	I'm thinking now I will get a cheap pico psu from eBay to covert the 12V supply to the 3.3v and 5v required. I could even use the regulated 5v from the pico psu to supply the 5v pins on the ta2020.