I am about to attempt a project of adding airport expess internals to a Topping TP20 amp. I was hoping to power the airport by soldering a few wires to the amp. It requires 5v and 3.3v.
I notice that the ta2020 chip has a few 5V pins. Would it be possible to pull some power from here to run the airport express, or would this cause problems? I have done a bit of searching and reading datatsheets but haven't found the answer. Can somebody shed some light on this?
I notice that the ta2020 chip has a few 5V pins. Would it be possible to pull some power from here to run the airport express, or would this cause problems? I have done a bit of searching and reading datatsheets but haven't found the answer. Can somebody shed some light on this?
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.