inputs to the amp board of the teac al700p? Im trying to piece together some kind of record of the mods done to this amp. With a lot of help from Puffin (thanks, bro!) Im updating my Apple Lossless library to run Squeezebox from my Netbook and an external drive and listen to this amp. Should be a pretty green setup. The netbook at full load consumes 17w, the Teac 45w, and I think the Squeezebox draws 10 watts. My preamp is a battery powered Bottlehead Quickie. So far so good but I want to finish modding this Teac and Ive been taking pictures of my mods to help someone later on.
Ill post a drawing of the board with the parts identified tomorrow.
I would appreciate your help in answering my questions so I can fill in the gaps of my mod knowledge. Thanks again Puffin and to anyone else who can contribute.
Ill post a drawing of the board with the parts identified tomorrow.
I would appreciate your help in answering my questions so I can fill in the gaps of my mod knowledge. Thanks again Puffin and to anyone else who can contribute.
Last edited:
Here's the schematic and I know enough to see the pertinent info is on page 2 but I dont know how to connect the parts and if they are all necessary if Im going straight from the RCA inputs to the amp board.
A-L700P_SCHEMATIC[1].pdf
I already have the 2.2 caps replaced on the board now where do the two resistors go and what values are they?
A-L700P_SCHEMATIC[1].pdf
I already have the 2.2 caps replaced on the board now where do the two resistors go and what values are they?
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.