New builder: Proposed BOM

[joekraska]

I am currently considering building an AMP from Class D's kits. I have built PC's many times, and wired home electrical panels, but have only rudimentary EE knowledge. However, I do think I have the gist of what's required. As a begin to put it all together, I'll likely get extremely frustrated if I forget things, so I wanted to make sure that I've covered all the major elements in advance. Here is what I believe a minimum BOM to be:

• AMP board.
• Toroidal transformer, rated to produce watts at XX% of amplifer's rated output.
• Power supply module.
• Power switch of choice.
• IEC connector for power.
• Mainline fuse rated at XX amps.
• CL60 thermistor inserted between signal equipment and ground.
• Front panel volume dial of choice.
• Rod to connect volume dial to potentiometer.
• Potentiometer for volume control (is this inserted on the low level line in?)
• Fans, if desired, and possibly a resistor inline to the fan to slow its speed, to make it quiet.
• Case of choice.
• Case feet of choice.
• Possibly grounded metal partitioning to elecromagnetically isolate the power supply from the amp board.
• Tools, elbow grease and luck.

Am I missing anything?

[theAnonymous1]

Originally Posted by joekraska

Am I missing anything?

Yes, directions to the "design and build" section of this site....

Design & Build - diyAudio

You don't need two threads about the same subject in the wrong forum.