Help in building amplifier using tas5630.

[kiranmsthampi]

Hey guys,
I am planning to build a amplifier using the TAS5630. But i have no idea about the circuit or PCB. Can anyone give a basic circuit?(with any power and output)

 

[sphinx]

http://focus.ti.com/lit/ds/symlink/tas5630.pdf

 

[Khron]

In the TAS5630 datasheet you can find schematics, plus a PCB for the TQFP variant of the chip.

In the TAS5630EVM (evaluation module) you can find the BTL / PBTL schematic and PCB for the HSSOP package.

Best of luck on the project

 

[kiranmsthampi]

Thanks for the circuits and details.But after seeing the circuit it seems to be a big challenge to build it. Actually i am not a new guy to amplifiers, i have built some amplifiers before even then I cannot understand some terms. I am listing them below. Where should i connect these?
/SD
/OTW1
/OTW2
/CLIP
READY
OSC_IO+
OSC_IO
/RESET
PVDD
Pls help....

 

[Khron]

In the pdf's for the chip and the EVM you should find answers to all your questions. It only takes some will-power and patience to read through those, all the way

 

[kiranmsthampi]

yep i got the answers but is there any need to connect these such as otw and reset when building an amp?

 

[mtripoli]

Hate to belabor the point but really, read the data sheets... Yes, OTW and RESET are needed... especially RESET...

 

[kiranmsthampi]

ok...i will take care of that...
hey is der any need to use a fan or just a heat sink??

 

[authlxl]

look my my design.if you have another question ,connect me,my email:authlxl@163.com

http://www.diyaudio.com/forums/class-d/152980-class-d-audio-who-these-guys-11.html