41hz Amp 4 Output Problems - diyAudio
Go Back   Home > Forums > Amplifiers > Class D

Class D Switching Power Amplifiers and Power D/A conversion

Please consider donating to help us continue to serve you.

Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
Reply
 
Thread Tools Search this Thread
Old 20th December 2007, 04:36 PM   #1
emu is offline emu  United States
diyAudio Member
 
Join Date: Nov 2006
Default 41hz Amp 4 Output Problems

Howdy,

I've been working on an AMP 4 and finally got it set up, but my output relay keeps tripping when input1 reaches a certain volume level; whenever the speaker needs a particularly high current level for a given note the relay cuts the signal out. I am not listening to the speakers all that loudly, and this ONLY happens on Output1; Output 2 works just fine at the same volume (in fact, output 2 has full volume range).

I'm not sure what to do at this point? I know the Tripath 2050 has overcurrent, over/under-voltage, and over-temperature protection - it's not over-temperature since it cuts out before the chip even has a chance to get hot. I've checked my 9V and 5V supplies and both are fine; I'm running the amp using a 22V transformer, and I do have a wire connected for R100.

Any help is very much appreciated, I tried asking the originator of the design at 41hz, and got a reply that the fellow no longer answers support questions and to ask the public if I had any questions... Guess I should have gotten a different kind of amp.

Thanks folks!
  Reply With Quote
Old 20th December 2007, 09:04 PM   #2
gfiandy is offline gfiandy  United Kingdom
diyAudio Member
 
gfiandy's Avatar
 
Join Date: Jul 2003
Location: Cambridge UK
I have not used this design at all so this is just conjecture.

Check if the same thing happens with no load attached. If it does then there is a low impedance path accross the output somewhere.

If not make sure the output device is securely attached to the heat sink with some kind of thermal transfere material. These sort of chips often have instantanious thermal overload protection and they can heat up internally very quickly if the thermal path to the heat sink is not good.

other than that check for any solder splashes or contamination on the PCB that could be causing leakage accross the fets.

Hopefully someone with more knowledge of this design will turn up.

Regards,
Andrew
  Reply With Quote

Reply


Hide this!Advertise here!
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Gu50 output problems beamnet Tubes / Valves 31 27th April 2013 05:53 PM
41Hz output relay question pinkfloyd4ever Class D 0 17th October 2008 03:52 AM
41Hz.com AMP8 - Output power when bridged MikeHunt79 Class D 8 29th March 2008 01:47 PM
IR2110 output problems G4ME Class D 7 15th January 2008 04:25 PM


New To Site? Need Help?

All times are GMT. The time now is 09:23 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio

Content Relevant URLs by vBSEO 3.3.2