diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Class D (http://www.diyaudio.com/forums/class-d/)
-   -   2 quick SI questions (http://www.diyaudio.com/forums/class-d/112507-2-quick-si-questions.html)

Decker 24th November 2007 09:22 PM

2 quick SI questions
 
I have repackaged one of my SI T-amps but am having a couple of problems:

1. LED not working even though I have 12 volts on the wires going to it. New LED time, or did I miss something?

2. I don't want or need a volume control. To simply go directly from RCA's to the board, which of the white wires do I solder to the RCA's? Right now, if you look at the board from above, with the edge connector closest to you, the two red wires (to the power switch) are on the left, the next two white wires are not connected, the middle white wire is connected to ground, and the two white wires furthest right are connected to the RCA's. I have power on the board but no sound. Am I using the right wires for inputs?

audio1st 26th November 2007 05:13 PM

1. check for correct polarity and if you have 12v, you need a 1k5 resisistor in series with LED...
2. the 2 white wires next to the red wires go to the rca's.

Decker 27th November 2007 12:30 AM

Thanks!:)


All times are GMT. The time now is 12:00 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2