Hello all
I have build my first GainClone with the LM3886T
It sounds good and i have no problems but i would like to try two designs more with the LM3886
One is the project of Rod Elliot and the other the schematic of Carlos FM
I try to make the PCB´s for both but i have a doubt
It´s posible to bridge the pins 2 and 4 for continue the V- rail?
Thanks
Miguel
I have build my first GainClone with the LM3886T
It sounds good and i have no problems but i would like to try two designs more with the LM3886
One is the project of Rod Elliot and the other the schematic of Carlos FM
I try to make the PCB´s for both but i have a doubt
It´s posible to bridge the pins 2 and 4 for continue the V- rail?
Thanks
Miguel
Attachments
Thanks a lot
I know thath the question is perhaps a silly question, i dont have electronic´s studies, and for me the reason for build a GainClone is the simplicity, but i have seen that many people dont use this pins except perhaps the pin11 usually bridget with pin4 and I asked me, Why?
Thanks again
Miguel
I know thath the question is perhaps a silly question, i dont have electronic´s studies, and for me the reason for build a GainClone is the simplicity, but i have seen that many people dont use this pins except perhaps the pin11 usually bridget with pin4 and I asked me, Why?
Thanks again
Miguel
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.