I've built this kit http://www1.jaycar.com.au/productVi...&pageNumber=&priceMin=&priceMax=&SUBCATID=557
I may have the paperwork at home with the artwork if you can wait a day or two for me to look.
I may have the paperwork at home with the artwork if you can wait a day or two for me to look.
Sorry - just realised this is a LM3876 - basically the same but sightly different pin arrangement. There wasn't any artwork just the layout drawing board size is 84x58mm
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
swaroopvg wrote:
Its not impossible try some good shops, Philips,CTR, are some manufacturers..by the way where r u located ?i find it almost impossible to find MKT type capacitors here in india...can u plz suggest a substitute...
50Watts RMS.and secondly is this 50 Watts RMS or 50 watss PMPO
The easiest way to calculate output power for a National amp that they call Overture series is to use their Overture Design Guide. You can find it here --> http://www.national.com/appinfo/audio/
It is in the middle column about 1.2 down the page. There is a file with directions as well. Very handy and pretty accurate.
-SL
It is in the middle column about 1.2 down the page. There is a file with directions as well. Very handy and pretty accurate.
-SL
Re: MKT capacitor
Please send me a PM, I'll send you some.
swaroopvg said:Hey ...
i find it almost impossible to find MKT type capacitors here in india...can u plz suggest a substitute...
and secondly is this 50 Watts RMS or 50 watss PMPO
Please send me a PM, I'll send you some.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Chip Amps
- Bridged LM3875 PCB