|Chip Amps Amplifiers based on integrated circuits|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
||Thread Tools||Search this Thread|
|19th April 2006, 12:46 AM||#1|
Join Date: Jan 2005
Location: New Brunswick
JL AUDIO 500/5 (dont worry, not in-car related)
ok, so i tried every trouble shooting test there was, and have determined there is something wrong with my amplifier.
the subwoofer channel works., and one of the rear channels work, the other three will not work.
so i cracked it open. trying to figure out what hapened.
i suspect the most likely cause is the outputs are fried. but i dont understand how 3 out of 4 channels refuse to operate.
i know what blown outputs sound liek, distorted mos-fet noise, and its in no way in accordance with the music.
the sound i get out of the 3 bad channels is a hardly audible treble that plays along with the song that is on.
anything i can try? i see indivdual "BIAS" jumper pins for each channel. anyone know what these can do?
i really dont want to send this amp to the distributor for new outputs.
My 100$ (final cost) line arrays will blow you away
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Audio and related gear||zargon1||Vendor's Bazaar||0||4th October 2008 03:47 PM|
|not audio or computer related?||karma||Everything Else||4||10th October 2003 08:22 AM|
|Some cool car audio related T's||griff||The Lounge||1||7th October 2003 05:44 AM|
|Here's a good problem for you (non-audio related)||nobody special||Parts||4||5th September 2003 10:18 PM|
|anybody doing non audio related diy projects||dlharmon||Everything Else||29||23rd November 2002 08:31 PM|
|New To Site?||Need Help?|