Peter's PCBs work fine in Stereo, bridged or parallel. You just have to install/not install certain components to get it to work in the mode you want.
edit: that thread is the "Audiosector" thread in the Vendor's bazaar, or www.audiosector.com
edit: that thread is the "Audiosector" thread in the Vendor's bazaar, or www.audiosector.com
Dominick22 said:I will affirm that AUDIOSECTOR is a great place to buy.
Peter Daniel is more than willing to assist and is also quick to do so.
I plan on conducting future business with him.
Good Luck,
Dominick in New Jersey
I agree completely.
mmmm Yes, but if you're following National's schema then you'll need to work on Peter's board a bit as it's configured only for non-inverting. For the inverting side you'll have to take input at a specific point, and change some of the resistor values, and not put some at all. It's simpler to have a small inverting opamp at the second input.
shameless plug -- see "BridgeClone"
http://www.tech-diy.com/chipamps.htm
and I'll send a reprint of the article.
http://www.tech-diy.com/chipamps.htm
and I'll send a reprint of the article.
LM4780 PCB
Here is my LM4780 PCB
Here is my LM4780 PCB
An externally hosted image should be here but it was not working when we last tested it.
jackinnj said:shameless plug -- see "BridgeClone"
http://www.tech-diy.com/chipamps.htm
and I'll send a reprint of the article.
I don't consider that a shameless plug at all since that is EXACTLY what he was asking for.
( I am affiliated only with myself )
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Chip Amps
- Lm4780 Bridged PCB