help with design

[demons_wing]

hey guys, just asking for the experts here to give me a hand..ive designed an LM3886 amplifier of my own, BUT im not sure what wvales to use..the schematic is given below..any help would be much appreciated

[tiltedhalo]

C6- 1uf
R3-1K
R5-22K
eliminate C8
R4-22.1K
R1-1K
C7- 22uf to 47uf polarized, tantalum, or NP 4.7uf to 22uf ect....
C3&C4 100uf to 1500uf your taste
C1&C2 100nf
Li- 7.4mh
R1- 10 ohm 2 watt
R2-2.7 ohm
C5-1uf
eliminate all component on mute pin. Use a 10k and a 100uf polarized cap - to ground.

[demons_wing]

thanks for the suggestions mate...but i have a question..how does the mute pin work?..is there an inbuilt switch inside and i can just link it to a pin of a microcontroller and pull it hi or lo??

[abid_rehan]

The answer the question about mute pin lies within the datasheet.

[tiltedhalo]

First I made a mistake, L1 should be .7mh dont know what I was thinking when I typed 7.4???? Just wind 10 turns of .4 enamel wire on the body of the 10 ohn 2watt resistor.
The mute pin needs 20ma at V- to shut off the mute feature. When the pin is open mute is active.

[demons_wing]

yes i understood that bit by reading the datasheet..the reason i have the Mosfet in there is because im making a preamp which is microcontroller controlled...therefore i can have input select and mute options...is this feasable?

[tiltedhalo]

should work, make sure the mos can pass enough current and as long as you can switch it high and low should work withou a problem.