X-Calibre : Hot Rodding Mauro Penasa's LM3886 design

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
I just can't justify making a run myself. It would take too much time and effort for only grief. Look at all the hassle others have gone through when they try to be altruistic.

The amount I would have to charge for boards to overcome the Pain-in-the *** factor would make them uneconomical.

The files I posted SHOULD be adequate for someone interested in producing a few boards for personal use. The issue is that without a lot of boards being produced, the price skyrockets. When I submitted the boards to BatchPCB.com the price (without shipping) was $55 per board. Expensive on a per board basis, but a bargain for such a small production run.

Just for full disclosure, I haven't produced these boards yet. Time will only tell if I will.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.