I'm building a gainclone for tweeters and mids using the design shown here: http://www.linkwitzlab.com/images/graphics/3886amp.gif . For Ci, I'm gonna use a 4.7uf cap, but im having difficulty installing it on this chip: http://www.chipamp.com/lm3875.shtml. The problem is that signal ground is connected to both the 20kohm input to ground and the 1k resistor right above Ci. If I put the cap on the signal ground, the cap would be in series with the 1k resistor AND the 20kohm input to ground resistor, which the design does not call for.
How do i solve this problem?
Thanks
Alex
How do i solve this problem?
Thanks
Alex
Well, you could try using a 50v/4.7uF blackgate-N. They're pretty small. They're available inexpensively over at http://www.kyoto-electro.com or any number of other parts suppliers (parts connexion, etc.)
On the plus side, they're usually a heck of a lot cheaper than an "audiophile" metallized Poly or film & foil cap.
On the plus side, they're usually a heck of a lot cheaper than an "audiophile" metallized Poly or film & foil cap.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.