XGC Board Try

[Idefixes]

Hello,

After building a LM3875 VBNIGC, i planned to build a PA100 to driver speaker based on scanspeak 15w4531g00/vifa xt25. These two in 9L box have 5ohm impedance and 87db sensitivity.
After reading GCsupersymety this option seduce me more than the PA100 since i have a built bosoz in stock. So here my latest XGC Board try. It's done under Proteus. I have too much problems with eagle.... so i follow under proteus.



The Metalman modify schématics. I intergrated the end part of the 338 regulated subbered PSU. 330nf from these will be direct soldered between lm3886 +/- pins. Electrolytics/small MKP near Lm3886 are 2200µf/50V // 100nf.



Marc

[Russ White]

I have been really wanting to build a SUSYGC I will be intently watching this thread. A PCB group buy would fully rock.

[Idefixes]

Originally posted by Russ White
I have been really wanting to build a SUSYGC I will be intently watching this thread. A PCB group buy would fully rock.

I've no possibility to produce board for group by but i can give proteus files if some want. What would be nice is that some one can validate this board.

Marc

[Carondimonio]

The PCB looks really great!
I' ve been checking the layout and didn' t see anything wrong, but I' d be nice to hear some PCB guru' s opinion...

BTW, I' d be interested in having a couple of PCBs, if there will be a GB...

[Idefixes]

Originally posted by Carondimonio
The PCB looks really great!
I' ve been checking the layout and didn' t see anything wrong, but I' d be nice to hear some PCB guru' s opinion...

BTW, I' d be interested in having a couple of PCBs, if there will be a GB...

Thanks. It will be nice allready to have another opinion before i try to realise this board.

Marc

[motherone]

I'm always down for trying a new GC variant Someone should get a GB going if the layout is good (with full credit going to Idefixes, of course).

I'd check the board, but I have the PCB analysis abilities of a mildly retarded squirrel.

[cjd]

Last I knew, BrianGT was working on a GB.

C

[Idefixes]

Originally posted by cjd
Last I knew, BrianGT was working on a GB.

C

Yes that's what i read in the dedicated topic, but since no news. My way is a little different : the final cut is not a GB, but my own use since à be abble to realise board at home. Of course every DIYer can have acces for his own use the board file under proteus. But for this time i need some help to check the current version and to optimize it. I have all necessary parts to built two mono blocs. Psu based on latest carlos version with 300Va/2x25v, mur1560 rectifier bridge,mallory 22.000µf/40V Cap, Lm338T regulator per bloc. I have two rubbish heatsink (200x200x40mm)



So the board and her optimisation are the last point to progress.

Marc

[Carondimonio]

Well, if somebody is going to organise a GB, it should be done in a way so that Idefixes gets his boards for free...
Just my 0.02...

Cheers,

Bruno

[jleaman]

Originally posted by Carondimonio
Well, if somebody is going to organise a GB, it should be done in a way so that Idefixes gets his boards for free...
Just my 0.02...

Cheers,

Bruno

I agree totally 100%