LM4780 PCB power transformer

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
I just populated a pair of Brian's LM4780 boards, and now it's time to apply voltage.

I am a bit unclear....is this bridge designed to accept a center tap transformer 25-0-25 or the AC output from each of two different, separate secondaries with identical voltages?
 
I am using 20-0-20 with dual independent secondaries -- this puts out a little under + and - 28V .

make sure that the LM4780 is snugged up to the heatsink --- I found that when it is properly affixed the distortion went down by about 0.03% This chip doesn't like to get real hot. (see the thread I started on heatsinking the LM4780).
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.