Evaluate and critique my pcb design

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Hi guys,

this is my first try to design a pcb. I am using express pcb to design the pcbs. I have designed a single layer pcb for Rod elliot's 24db roll off Linkwitz-riley filter. Also i have designed a Power supply pcb for the same. Please go through the designs and bring out the flaws in it. I am sure there are lot of scope for improvement. I would be gald if some one points out the corrections.

schematic ,pcb and slik layer of filter and power supply is attached.

(attachment deleted by moderators)
 
Difficult to post gif files

There are 3 gif files in each of the zip file. So that makes it 6 files. It is difficult to post 6 of them separately. As ir was mentioning u just need to right click and check for sanity in case of any doubt.

Anyway since no one is replying to the post its alright. I will figure out and re work my design myself instead of depending on others.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.