How to wire up an Alps 100k Stereo Pot?

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Jump to Latest
ble0t

ble0t

Member
Joined 2004
A friend of mine gave me this pot to use with my NIGC (which is under construction). First off, is 100k going to be OK as far as the gain is concerned? Second, I know to run the input to one of the outside pins and then use the middle (wiper) pin for the output. My question is, do I run the signal ground to the remaining pin? Or do I run the signal ground to the PCB directly (I am using Brian's PCB kit)? Thanks!
 
S

Sherman

Member
Joined 2004
You can either-
1- run the remaining pin to signal ground (and you also need to run the RCA input ground there also or

2- you can tie the two together before signal ground on the board and run a single wire to the board.

I chose option 1 with mine and it works fine.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Top Bottom