Checklist for my first gainclone

[jcmkk]

I'm new to these forums. I've been reading a lot about the gainclones recently and two weeks ago when the call went out for the final orders of Peter Daniel's chasis, I pulled the trigger. Now I need to make sure I have all of the other parts to build the amp. I think I've got it all figured out, but I wanted to check anyway. So here's what I ordered from Peter:

-Integrated amp chasis kit (with holes for Cardas patented binding posts)
-Side panels
-AC entry module (with fuse)
-Volume pot
-Grayhill source selector switch
-Set of cones

Here's what I plan on ordering:
-CPBP-CRS Patented System-Copper Post/Rhodium over Silver x 2
-Cardas CTFA Economy female RCAs x 6 (these will fit fine right?)
-AVEL Y236750 330VA 25V+25V TOROIDAL TRANSFORMER (this will fit also right?)

What I haven't decided on yet:
-hookup wire (I'm not sure what I should be looking for here. Anyone have any suggestions? So far I'm planning on ordering the parts from diycable.com and partsexpress.com so if they sell the wire then even better.)

Is there anything I missed?