diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Chip Amps (http://www.diyaudio.com/forums/chip-amps/)
-   -   Mini My Ref Rev C (http://www.diyaudio.com/forums/chip-amps/238212-mini-my-ref-rev-c.html)

jlester87 25th June 2013 08:44 AM

Mini My Ref Rev C
 
4 Attachment(s)
Hi,

I've created a layout for a mono amp based on My Ref Rev C.

No speaker protect and no onboard supply. Only good as an add-on module for an existing amp.

Credits to Mauro Penasa for the schematics.

linuxguru 25th June 2013 08:53 AM

Thanks for the layout and the concept. However, it's prudent not to omit the speaker protection - there are a wide variety of situations (both malfunctions as well as marginal component values) in a MyRef where the speaker output latches to V+ or less commonly, to V-, and this will almost certainly destroy any woofer instantly.

The speaker protection circuitry works very well to protect the speakers from DC on the output, and doesn't cost much or occupy a great deal of board area, and I would strongly suggest that it be retained.

jlester87 25th June 2013 10:33 AM

Thanks for the suggestion. But the placement and routing for the speaker protect will be difficult and needs many jumpers.

Yes I think it is mandatory to have a speaker protection with this amp. Just use external speaker protect :)

jlester87 29th June 2013 02:54 AM

2 Attachment(s)
Top layer for double sided pcb

AndrewT 29th June 2013 09:49 AM

Pin5 desperately needs decoupling. The trace is far too long.
Are you not a believer in MF and HF decoupling?
You have none !

jlester87 29th June 2013 11:04 AM

Thanks for the suggestion. No prob, the trace can be cut off and you can put jumper directly to the pins 1 and 5 of the IC. (If you're a believer)

jlester87 29th June 2013 03:57 PM

3 Attachment(s)
As requested.

AndrewT 29th June 2013 04:05 PM

Still no HF decoupling.
National, for all their misguided information, do tell builders to include both MF and HF decoupling.

jlester87 29th June 2013 04:40 PM

Hi, you can put it on the underside of the 220uf caps

AndrewT 29th June 2013 06:34 PM

Underside, yes.
But NOT on the electros.
At the chip pins and to Power Ground.


All times are GMT. The time now is 10:43 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2