I use to be in the electronics industry hand and foot. I always wanted to make powerful amp that SoUnds good. I know how to make pcb's. I know how to trouble shoot. I want a good PCB layout for a BPA 200. I have most of the parts for it. Help this newbie out. Please. Oh, schematic would help. I have the one for the PCB AN-1192. I have decent power supply skills. I just want to get my feet wet again.
Thanks.
Audioenthusiast2012
Thanks.
Audioenthusiast2012
Last edited:
Audioe..2012
Here's something similar. Keep in mind those power ratings are load related. In a recent LM3886 x 3 project I learned the sheer output volume with an 8 ohm speaker was about the same as a single chip. I'm not sure if that applies to all the multiple LM3886 designs, but it certainly was true in my builds.
300W Mono LM3886 X 4 + NE5532 POWER AMPLIFIER KIT | eBay
Here's something similar. Keep in mind those power ratings are load related. In a recent LM3886 x 3 project I learned the sheer output volume with an 8 ohm speaker was about the same as a single chip. I'm not sure if that applies to all the multiple LM3886 designs, but it certainly was true in my builds.
300W Mono LM3886 X 4 + NE5532 POWER AMPLIFIER KIT | eBay
Last edited:
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.