|
|||||||
| Home | Forums | Rules | Articles | Store | Gallery | Blogs | Register | Donations | FAQ | Calendar | Search | Today's Posts | Mark Forums Read | Search |
| Chip Amps Amplifiers based on integrated circuits |
  |
|
|
|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving |
 |
|
|
Thread Tools | Search this Thread |
14th June 2011, 01:15 AM
|
#1 |
|
diyAudio Member
Join Date: Jun 2011
|
Help with KC1200.1 amp
A guy at work gave me an amp to see if I could fix for him since he knows i work on electronics. It is a Kicker 1200.1. I dove into to it tonight and found out it has been repaired before by an unknown source. After inspecting this unit I see that C275 has blown. I was wondering if anyone out there could tell me the value of C275 so I can replace it, or point me to a schematic where I can get the value. Thanks for any and all help!3
|
|
|
14th June 2011, 07:09 PM
|
#2 |
|
diyAudio Member
Join Date: Jun 2011
|
Kicker actually answered this for me. The capacitor you need is 10 uF / 16 v, it may be better that you use 10 uF / 25V.
Thanks to diyAudio for allowing the post. |
|
|
|
| Thread Tools | Search this Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FS- Twisted Pear Buffalo 32S Board & System New & Unused | secretriches | Swap Meet | 1 | 10th August 2009 02:17 PM |
| Modify & build out (2) Western Electric 300B / 2A3 Hammond monoblock amps & UTC LS-5 | quality sound | Tubes / Valves | 0 | 9th May 2009 03:59 PM |
| Krell KSA 80 bias & dc offset check & adjust procedure | Clouseaupte | Solid State | 3 | 9th August 2007 09:39 AM |
| DIY-AMP <ZAS> Low THD & IM high bandwith | murphy | Solid State | 18 | 30th December 2005 10:28 AM |
| New To Site? | Need Help? |
