|26th June 2010, 01:07 AM||#11|
Join Date: Jun 2008
Currently no way of scanning the original schema and posting.
Apologies for this.
I can of course put DC blockers on the output of my pre amp and then experiment I guess.
I do however like the sound of increasing the value of caps if there is an
opportunity to extend the bass response, thanks for that.
If I understand correctly, the feedbck resistor ( pick off point ) is before the 1 OHM resistor I'd like to remove.
The wire link idea is an example of my ignorance, assuming that I somehow break circuit if I leave out a component.
Forget it, that won't happen now.
As I said earlier, it sounds very good and far beyond my humble expectations.
It is significantly better than my previous power amp but the problem is that this site can make you think beyond your own intelligence levels.
I'm not one bit ashamed of that, I love this sport and want to learn and reach the maximum I can have.
The ' less is more principle ' has got a firm hold.
The risk I take is annoying the people who REALLY understand and I'm sure I've done this a few times.
I'm sure the likes of Peter Daniels wouldn't even look at my threads let alone contribute to them.
Thank you for your advice, most welcome
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|1st Pass at 1st Phono Preamp; Comments?||nullspace||Tubes / Valves||16||1st December 2009 09:47 PM|
|1st Gainclone||AndrewGM||Chip Amps||16||26th June 2008 10:53 PM|
|My 1st SUB||scottfx2||Subwoofers||12||9th February 2005 08:20 AM|
|loud hum w/ 1st Gainclone||JazzzSpazzz||Chip Amps||24||8th December 2004 04:21 PM|
|my 1st alphaTL||planet10||Multi-Way||22||27th August 2003 08:27 PM|
|New To Site?||Need Help?|