Hello all,
I am in the process of building an audio sector lm4780 kit!!
my intention is to use 1 chip per channel in a bridged or parallel config. to drive an 8 ohm load to get the highest possible output from the amp.
what are people's opinions on bridged or parallel ??????????????
I am in the process of building an audio sector lm4780 kit!!
my intention is to use 1 chip per channel in a bridged or parallel config. to drive an 8 ohm load to get the highest possible output from the amp.
what are people's opinions on bridged or parallel ??????????????
Bridged sounds better, but you need a balanced signal connected to the amp and the speakers should be at least 6 ohm (8 ohm is still better).
In one of my systems I'm still using LM4780 bridged monoblocks, connected to ML380S preamp: http://www.diyaudio.com/forums/showthread.php?postid=636576#post636576
In one of my systems I'm still using LM4780 bridged monoblocks, connected to ML380S preamp: http://www.diyaudio.com/forums/showthread.php?postid=636576#post636576
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.