Bought the kit from EZamps website, its another Gainclone using LM3886 and the DIY step by step instructions are very easy to follow but I substituted the resistors with Vishay and Caps I used Cerafine also upgraded the NE5532 OPamp to LM4562. So far i'm impressed with this amp it sounded very good driving an 8 ohm ONIX XLS speakers, the detail, imaging and clarity on mid and highs are amazing.
Specifications:
Power Output: 4 ohms 50WRMS, 8 ohms 38WRMS
Bridge Power: 8 ohms 100WRMS
THD+Noise 0.012%
S/N Ratio: <-92dB below 1W, 8Hz-20kHz
Average DC Offset: <1mV (Tempco Compensated)
Frequency Response (-3dB points): 8-50kHz +/-0.1dB
Instantaneous DC Offset: 0.0009V
PCB: 4.2 x 3.0" Double sided, silkscreened
Heatsink: 2.38 x 4.56 x 0.9" Black Anodize 6061 Aluminum
Specifications:
Power Output: 4 ohms 50WRMS, 8 ohms 38WRMS
Bridge Power: 8 ohms 100WRMS
THD+Noise 0.012%
S/N Ratio: <-92dB below 1W, 8Hz-20kHz
Average DC Offset: <1mV (Tempco Compensated)
Frequency Response (-3dB points): 8-50kHz +/-0.1dB
Instantaneous DC Offset: 0.0009V
PCB: 4.2 x 3.0" Double sided, silkscreened
Heatsink: 2.38 x 4.56 x 0.9" Black Anodize 6061 Aluminum
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.