everyones audio setup?

[Flyin11]

Subs and box to change this week

Headunit: Kenwood KDC-MP4028
CD Changer: Kenwood 6 disc (Don't remember the model)
Tweeters: Stock tweeters that came with the 2003 Civic
Front Speakers: Kenwood 6 1/2's (Don't remember the model)
Rear Speakers: Kicker 3 way 6X9 speakers
Amplifier: Just replaced a old school PPI Sedona 50ix with a Alpine MRP-M450 to get set for my next set of subs.
Subs: 2 Rockford Punch 8ohm 12" Stage 1 subs (wired in parallel for a 4ohm load) that I bought from Crutchfield in a ported box.

Just got a new sealed box today and will be getting 2 JL Audio 12" 12W1v2 4ohm subwoofers to replace the other subs and I will be trying to sell those 2 12's on Ebay without the box to get something for them. Will wire them in parallel to get a 2ohm load and have the Alpine pushing 400watts RMS into them. The box is 1.4 cu foot and the speaker page says you need 1.25 cu foot so the guy at the audio place told me to put some poly-fil in it and I should be fine. Can't wait to hear those babies pound!!

[Flyin11]

My final updated setup

Headunit: Kenwood KDC-X891
Tweeters: Stock tweeters that came with the 2003 Civic
Front Speakers: Kenwood 6 1/2's (Don't remember the model)
Rear Speakers: Kicker 3 way 6X9 speakers
Sub Amplifier: Rockford P300-1
Highs Amplifier: Alpine MRP-F240
Subs: 2 JL Audio 12" 12W1v2 4ohm wired in parallel for a 2ohm load in a 1.27cu ft sealed enclosure
Rockford Fosgate 1 Farad Capacitor

[crs1]

2000 chevy silverado standard cab

alpine cda9853
2 infinity kappa 124.7W subs in 1 cube ft sealed box each
infinity reference 1600A mono amp
infinity reference 7541A amp
infinity kappa 60.7cs with tweeters in the A pillars firing at the windshield
infinity 4x6 plates in the B pillars can't remember the model #

[Jonny Hotnuts]

I am building a stereo for my twin turbo toyota tundra.

Its a mix of old school and new items.

Head unit:
Currently using a Kenwood Excelon (cant remember what one it is but it was the best unit they offered in 2000).

I am now looking at the Eclipse CD7100 8 volt.

The front stage:
Dynaudio 240 GT set powered with (2) A/D/S/ PQ20's run 2 channels per side.


Sub drivers:
Considering a few but will likely end up with the Fi Q series 10" and will run 4. www.ficaraudio.com


Sub amps.
I own 4 kicker ZR1000's but will likely ebay them for something else. They are great amps but very power hungry and not really in the same league as the front stage components.

Was considering the American made TO3 case Tru Billet or copper series amps. I have never heard one but really like what they have on their site. http://www.trutechnology.com/product...tseries001.htm

[bulldogfreddy]

Kenwood 911dvd
15.4 flip down
4 12's pioneer
2 hifonincs brutus 2006
1 crossfire 302cfa
kenwood comp 6 1/2 in all four doors
2 battiers and upgraded alt.

In a Chevy Avalanche

[Safe_Cracker]

Wow, I feel out of place! This is a daily setup so here it goes....


2001 Pontiac GTP

Pioneer Deh P9800BT
Cadence CVL (1 pair 5K, and 1 pair 6k all up front)
Kicker SX900.4 (for the above)
TC Sounds 5200 (4hp driven subwoofer, Ti cone)
IA 40.1, produces around 6K rms on 16V system (16-18.3V)
1 BatCap 8400 @ 16V, 2 HC2200 @16V, sit at 18.3V fully charged (float)
Iraggi 300A Amputator series externally regulated, max charge voltage is around 19.3V as required by the BatCap 8400
Fisher Customs enclosure with interchangeable ports (30, 35 and 40hz tune)
3 runs of 1/0ga wire.


Polo..