Memphis srx 500d.1 ps fets???

[Eaudio2013]

im working on this memphis amp its the memphis srx 500d.1 and every time i put my new ps fets in Irf1010e it maxes out my power supply at 80amps
and they burn up
the gate resistors are fine im just not shore what is throwing them off
any ideas on what to check thanks

 

[Perry Babin]

Post a photo of the board.

Check the drive signal at the gate pads of the FETs before installing the FETs.

Have you checked the output transistors?

 

[Eaudio2013]

memphis amp

i think this is whats causing the ps fets to burn up im not getting my 5v on every output
im trying to find the small smd transistor that is bad but its hard to tracing it back
im not shore if it would be on the main board or on a board that stands up
in the amp
i can take more pics of them amp if it would help