I'm starting a new thread for this one. So far I replaced output transistors with new ones all matching. Even replaced source resistors. I get audio clear audio but as soon as it's turned up past a certain volume it'll go into protect. I'm not sure what R1105, R1098, 1090 are I dint replace those. Any ideas what's causing it to go into protect? Thanks!
Attachments
Gotcha! Only the left channel puts amp into protect when volume is turned up half way the other channel doesn't. What I noticed even with no load connected amp will still go into protect. I replaced the outputs in the left channel as well as the source resistors since they were out of tolerance. It plays music on hp and ap and bass signal isn't distorted either.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.