OK this is the Titan TXI 1500d I have.
Pic just taken
So this would be 470 kOhms , also tested with an ohmmeter.
Pic just taken
An externally hosted image should be here but it was not working when we last tested it.
So this would be 470 kOhms , also tested with an ohmmeter.
can u help me
Excuse me friend, will you remember the process you did for the repair? I have a Steelpro 1.2000D and it burns an IRF 1310N, it also uses the HIP4080. I am an electronics student, I do not have much experience, I was wondering if it is necessary to order the IRF 3710Z transistors (change only the one that broke down or absolutely all of them for this one) and their driver, or if it would be better to change the rectifier mainly.
Excuse me friend, will you remember the process you did for the repair? I have a Steelpro 1.2000D and it burns an IRF 1310N, it also uses the HIP4080. I am an electronics student, I do not have much experience, I was wondering if it is necessary to order the IRF 3710Z transistors (change only the one that broke down or absolutely all of them for this one) and their driver, or if it would be better to change the rectifier mainly.
Please don't post in a repair thread that was started by someone else unless you are trying to help them.
Start a new thread if you need help with a repair of your own.
http://www.bcae1.com/temp/newthreaddiy01.png
Start a new thread if you need help with a repair of your own.
http://www.bcae1.com/temp/newthreaddiy01.png
- Home
- General Interest
- Car Audio
- Hifonics txi 1500d output transistor !!