diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Car Audio (http://www.diyaudio.com/forums/car-audio/)
-   -   Orion XTR 1500.1 (http://www.diyaudio.com/forums/car-audio/230665-orion-xtr-1500-1-a.html)

allaroundsound 22nd February 2013 11:02 PM

Orion XTR 1500.1
 
Amp turns on, shows rail voltage, but does not produce audio. When the subsonic filter button or phase 0/180 degrees is pressed, the test woofer jumps. The woofer also jumps when turning the gain pot. All of these tests are done with NO rca input. I've also noticed a possible continuity problem when testing main ground to rca shielding.

Any starting help would be welcomed. [IMG]http://i50.tinypic.com/24yp9v5.jpg[/IMG]

[IMG]http://i45.tinypic.com/2im3kau.jpg[/IMG]

[IMG]http://i46.tinypic.com/10ntgyv.jpg[/IMG]

Perry Babin 22nd February 2013 11:29 PM

Check all of the 10 ohm resistors on the outputs of the various regulators. In a similar amp, they commonly open.

allaroundsound 23rd February 2013 03:44 PM

are you referring to smd style resistors on the driver boards?

Perry Babin 23rd February 2013 05:37 PM

1 Attachment(s)
I don't have anything on this amp but the smaller version has a problem with the 10 ohm resistors on the output of the various regulators. They are highlighted with green arrows in the attached photo. They won't be exactly the same in your amp (or may not even exist in your amp). I think that there are at least 8 of them and maybe more.

allaroundsound 24th February 2013 09:16 PM

I believe that my tone generator had a dead batt at first test. The amp has output, sounds clean, still has turn off pop and pop when adjusting gain or depressing phase and subsonic.

Perry Babin 24th February 2013 10:00 PM

Are you turning it off by removing remove voltage (but leaving B+ and ground connected)?

allaroundsound 24th February 2013 11:48 PM

removing only remote turn on.

Perry Babin 24th February 2013 11:52 PM

Does the relay disengage precisely when you remove the remote voltage?

allaroundsound 25th February 2013 02:25 AM

All pins that I've tested that are driven by this circuit seem to be losing voltage at the time that I remove remote turn on

Perry Babin 25th February 2013 10:07 PM

Do you hear the relay disengage precisely at the point when you remove remote voltage?


All times are GMT. The time now is 03:27 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2