I figured it out.
I should have known, when all I did is reflow some solder to cold joints and the channel had distorted audio.
The solder followed the legs of the D41D8 transistor to the top side of the board and made a solder bridge between the base and collector.
The bridge was not visible because it was under the transistor and it was a very tiny bridge.
The amp works awesome.
Thanks Perry.
I should have known, when all I did is reflow some solder to cold joints and the channel had distorted audio.
The solder followed the legs of the D41D8 transistor to the top side of the board and made a solder bridge between the base and collector.
The bridge was not visible because it was under the transistor and it was a very tiny bridge.
The amp works awesome.
Thanks Perry.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.