diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Car Audio (http://www.diyaudio.com/forums/car-audio/)
-   -   dls cad 11 (http://www.diyaudio.com/forums/car-audio/223503-dls-cad-11-a.html)

rrae 13th November 2012 05:28 PM

dls cad 11
 
I cannot get +/- 15v regulated voltage output of regulators. I took a brand new 7915 and 7815 regulators, i get only 13.66V on their inputs. Supply voltage on terminals is 13.88V. The rails are +/- 33.3V. Amp ground terminal as reference. It powers up "fine", no protection. If someone don't have schematic, i can send.

Perry Babin 14th November 2012 12:20 AM

If no one can help, post a photo of the board.

rrae 14th November 2012 06:04 AM

Right now i can only show the pictures from this topic - http://www.diyaudio.com/forums/car-a...-cad-11-a.html
Later i can send better quality pictures.

Perry Babin 14th November 2012 07:11 AM

Those are good enough for now. I don't have the exact diagram but I have something close that may be of some help. Email me and I'll send it to you.

babin_perry@yahoo.com

rrae 14th November 2012 07:20 AM

I have mad11 diagram which is almost the same, only difference that "mad" was made for russian market. If You Perry don't have it, i can send it to you.

Perry Babin 14th November 2012 07:22 AM

Sure, send it.

rrae 14th November 2012 07:26 AM

Check your inbox.

Perry Babin 14th November 2012 07:33 AM

The rail voltage is much too low. Are the power supply FETs intact?

Are they being driven properly?

If you don't have a scope, check the drive with a multimeter set to DC volts. You should read approximately 5v with the black probe on leg 3 and the red probe on leg 1. Check the FETs for both power supplies.

rrae 14th November 2012 04:16 PM

I did not find any shorts at power supply fets.
They are not driven properly, drive voltage for all fets was 1.38-1,43V.

Perry Babin 14th November 2012 04:26 PM

Post the DC voltage on all pins of the SG3525.

Pin 1:
Pin 2:
Pin 3:
Pin 4:
Pin 5:
Pin 6:
Pin 7:
Pin 8:
Pin 9:
Pin 10:
Pin 11:
Pin 12:
Pin 13:
Pin 14:
Pin 15:
Pin 16:


All times are GMT. The time now is 03:20 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2