Kicker 750.1

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Jump to Latest
M

mike49504

Member
Joined 2006
Q02 has its collector connected to ground so thats a MMBTA56

Q11 has its base connected to ground Q05 appears to be the same as Q02 ..
Q05 is marked ASG any ideas on a part number for it ?

Theese are the power supply drivers Q11 has its base connected to Leg 3 of the 3205's

Q02 has its collector connected to leg 3 of the 3205
 
Last edited:
M

mike49504

Member
Joined 2006
That transistor is out of circuit since it was defective and badly burned..

From the collector (3rd leg) to the 3205's 3rd leg i get 46.7K ohms

Q05 has its base connected to the 3rd leg of the 3205 also and i get the same readings off that transistor as well and its marked ASG

So im assuming Q11 and Q05 are both the same..
 
Last edited:
P

Perry Babin

Member
Joined 2003
bcae1.com
Is this the pin configuration that you're using?
 

Attachments

  • SMDpinout01.jpg
    SMDpinout01.jpg
    49.6 KB · Views: 64
M

mike49504

Member
Joined 2006
No ..


If thats the right order then Q11's collector would go to ground

Q02's emitter would go to ground and leg3 of the 3205

I looked at the board at Q05 and Q11 should be the same Marked ASG

Q02 and Q26 are the same marked ALG

So the MMBTA56's should work in both locations correct ?
 
Last edited:
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Top Bottom