diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Car Audio (http://www.diyaudio.com/forums/car-audio/)
-   -   HiFonics Boltar VIII harness (http://www.diyaudio.com/forums/car-audio/204891-hifonics-boltar-viii-harness.html)

Marc03 20th January 2012 01:25 AM

HiFonics Boltar VIII harness
 
I have an old Boltar amp, looking to find the wiring harness/plugs for it.

I see some listed on Ebay, but they look nothing like what I need.

Thanks.

Dr Zeus 20th January 2012 01:32 PM

I'll be in contact with a Hifonics Thor VIII today at a local shop (its for sale likely) and its got a decent plug. I'll snap you a picture if it helps at all.

Dr Zeus 20th January 2012 07:34 PM

http://i886.photobucket.com/albums/a...120_123132.jpg

http://i886.photobucket.com/albums/a...120_123125.jpg

Marc03 20th January 2012 08:07 PM

Thanks.. Any markings on it? or part numbers? It is probably an AMP or similar part, maybe I can find it that way?

Looks like the power harness on this one is missing, someone just rigged them up?

Perry Babin 20th January 2012 08:13 PM

Maybe one of these will work.
Digi-Key - ED1720-ND (Manufacturer - EDZ950/5)

http://dkc3.digikey.com/PDF/US2011/P0349.pdf

There are 2 pin spacings. One is 5mm, the other is 5.08mm (0.2"). Order the one with the correct spacing.

Marc03 20th January 2012 08:32 PM

Could be.. Maybe Dr. Z could measure his for me?? This of course is just the speaker one, I still need to figure out the power connector.

Thanks again Perry!

Dr Zeus 20th January 2012 08:41 PM

No numbers. My thumb is about 1" wide. The plug is probably smaller than adequate even for this thor amp. Theres a chance maybe the Boltar amp uses a bigger plug? it just seems small to me, smaller than what PPI or Orion used to use.

If it were me and I had to guess, I'd buy the plug with 0.2" spacing as this is an american amp. 5mm may not work :)

Yea the pictured Thor amp has power hard-wired.

Marc03 20th January 2012 08:45 PM

I may just try and replace the connectors with something else then.. I was concerned that it may hurt the resale value (if I ever decide to sell), but it is worthless the way it is now!

Perry Babin 20th January 2012 08:55 PM

If you don't have a dial caliper, use a DIP IC. If the pins on the board line up perfectly with every-other pin, it's 5.08mm. If it's not a perfect match, it's likely 5mm.

mike49504 20th January 2012 10:21 PM

You also may wanna try contacting ZED AUDIO to see if he has some plugs for sale..


All times are GMT. The time now is 04:05 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2