jl 500\1 power supply doesnt turn on

[trevor420420]

I have a jl 500\1 rev 10 that doesn't power up and need help. I have opened it up and power fet's and gate resistors test ok. Does anyone have a schematic for this amp?

 

[Perry Babin]

Post the DC voltage on the pins of the connector near the power terminal block. Use the pin numbering shown in the attached image. Copy and paste the following into you reply.

Pin 1:
Pin 2:
Pin 3:
Pin 4:
Pin 5:
Pin 6:
Pin 7:
Pin 8:
Pin 9:
Pin 10:

 

[trevor420420]

Thanks for the response. Test found # 8 at 0 volts. I will test again and post my results for the rest.

 

[trevor420420]

power source 12.9v
pin 1- 4.94v
pin 2- -12.55v
pin 3- 12.55v
pin 4- .5v and rising
pin 5- 11.71v
pin 6- 12.1v
pin 7- .665v
pin 8- .3v and droping
pin 9- 11.92v
pin 10- 7.2mv

 

[Perry Babin]

What revision is the preamp board?

In the future, please don't use hyphens as separators. They can be mistaken for a negative sign.

 

[trevor420420]

rev 10

 

[Perry Babin]

What is the DC voltage measured directly across the two points indicated by the arrows.