Do all of the audio op-amps have positive and negative supply voltage?
Is the amp in protect mode?
Do you see a pulse of DC on any of the speaker terminals when you power it up? Have the scope probe on the speaker terminals when you apply remote and continue watching for about 10 seconds after applying remote voltage.
Is the amp in protect mode?
Do you see a pulse of DC on any of the speaker terminals when you power it up? Have the scope probe on the speaker terminals when you apply remote and continue watching for about 10 seconds after applying remote voltage.
On pin 4 of all op-amps i get 0.62 volts
On pin 8 of all op-amps i get 1.28 volts
Protect light is not on but the low ohms light is on all the time along with the power light..
On both + speaker terminals i get 0.08 volts on start up
On both negative speaker terminals i get 0.66 volts on start up
On pin 8 of all op-amps i get 1.28 volts
Protect light is not on but the low ohms light is on all the time along with the power light..
On both + speaker terminals i get 0.08 volts on start up
On both negative speaker terminals i get 0.66 volts on start up
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- General Interest
- Car Audio
- JL Audio 500/1