diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Car Audio (http://www.diyaudio.com/forums/car-audio/)
-   -   The Punch 150 Amplifier (http://www.diyaudio.com/forums/car-audio/186639-punch-150-amplifier.html)

cland20 8th April 2011 04:46 AM

The Punch 150 Amplifier
 
Looking to repair my old punch 150. Has a few componets that look to be burnt up inside the amp. Not sure what the technical name for them are but they have stamped on them "Buz11 R931" with the Motorolla logo on there also. This is going to be my first repair attempt on any amplifier and was looking for some guidance. I would like to know what I need to buy to get this thing pumping again. I believe it is an early 90's model amp 75 wats rms power at 4ohms. I think I managed to find the board number on it "Rockford cp PC-150 K3" PATENT#3883832 Thanks in advance for any and all help ya'll :D

seankane 8th April 2011 06:13 AM

Dont have a schematic in front of me so can you post a pic of location?

I have a Punch 150 here but it is a K1 model. Does the amp power up?

What are the issues the amp has? The power supply in the one I have uses BUZ 11 and the gates are IN4746 zener diodes. Sometimes Rockford used the same power supply FETS and output FETS.

Please post a pic or give a little more info.................Thanks

cland20 11th April 2011 02:31 AM

Pictures punch 150 k3
 
Thanks for the quick reply Sean, Sorry about the lack of info...I thought that I included three pics but apparently they didn't upload. I'n not 100% sure what the gates look like but from what I can see on the board no parts with the number IN4746. Sean, do you need a pic of the location of the BUZ11, or a pic of the schematic I will try to post the pics again.


http://pic80.picturetrail.com/VOL102.../396188766.jpg

http://pic80.picturetrail.com/VOL102.../396188765.jpg

http://pic80.picturetrail.com/VOL102.../396188762.jpg

http://pic80.picturetrail.com/VOL102.../396188761.jpg

http://pic80.picturetrail.com/VOL102.../396188760.jpg

http://www.google.com/imgres?imgurl=...w=1366&bih=656

Perry Babin 11th April 2011 03:40 AM

1 Attachment(s)
I'd recommend replacing the BUZ11s with IRF3205s. Replace the two transistors indicated by the arrows. Also replace the resistors in the rectangles with 47 ohm resistors.

Have you checked the output transistors?

cland20 11th April 2011 11:12 PM

K-3
 
Perry, thanks for all the pertinent info. I will read up on it tonight first and possibly check the boards transistors / outputs...after I figure out what they physically are.

seankane 12th April 2011 12:43 AM

In pic 2 you have posted I would replace the orange barrel type connectors which are zenner diodes, there part number is IN4746.


All times are GMT. The time now is 09:11 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2